N1913A and N1914A EPM Series Power Meters Firmware Revision History
-------------------------------------------------------------------
Pls refer to "www.agilent.com/find/epm for more details.

Release A.01.09 (10 September 2013)
-------------------------------
- Resolved the issue of N191xA occasionally does not reply to the TCP socket connection requests from the customer's controller.
- Enable TCP keep alive value configuration through web browser
- Support USB-LAN adaptor for USB sensor connection
- Resolved the issue of meter unable to accept new connection after many LAN restart
- Resolved the issue of E9300H/ 1H having high offset after 1mW ref cal.


Release A.01.08 (20 March 2013)
-------------------------------
- Provide compatibility with U848xA series USB Thermocouple Sensor firmware A.01.01 only
- Resolved DISP:ENAB 0 bug
- Resolved erroneous error message displayed when self test with the 8481D/8485D/8487D 
- Resolved minor display issues in Save/Recall menu



Release A.01.07 (22 Feb 2013)
-----------------------------
- Fixed timeout error for SERV:OPT? command
- Allow user to set frequency to 0Hz
- Bug fix on FETCH:DIFF? command
- Bug fix on 436/ 7/ 8 emulation codes
- Fixed CW self-test issue



Release A.01.06 (02 Jan 2012)
-----------------------------
- 200ft cable supportability
- Bug fix on *DDT? command returning unknown content on visa socket connection
- Inclusion of SERV:OPT? command 
- Bug fix on unwanted frequency change when working with U2000 sensors.
- Bug fix on SYST:LANG SCPI command 
- Bug fix on synchronization of Cal Factor value on GUI during remote operation.

Release A.01.05 (30 Sept 2011)
------------------------------
- Bug fixes on compatibility with USB sensors
- Bug fix on 436/7/8 emulation codes (option 200)
- Message queue size increased

Release A1.01.04 (30-May-2011)
---------------------------------
Display measurement data on power meter once the USB power sensor is connected at power ON.

Release A.01.03 (23 August 2010)
--------------------------
- Enable N848x (CFT option) for 436/7/8 emulation codes (option 200) 
- Enable accepting commands with/without newline for 436/7/8 emulation codes (option 200)
- Bug fix on 436/7/8 emulation codes (option 200)

Release A.01.02 (10 March 2010)
--------------------------
-Upgrade communication board flash codes

Release A.01.01 (1-Jan-2010)
-----------------------------
- Enabled recorder output auto-scaling feature
- Bugs fix on 436/7/8 emulation codes (option 200)

Release A.01.00 (9-June-2009)
-----------------------------
Initial release.